Table of Contents
Advertisement
4.24 Touch pad/Fingerprint sensor board
4.24 Touch pad/Fingerprint sensor board
Removing the touch pad/Fingerprint sensor board
The following describes the procedure for removing the touch pad/fingerprint sensor board
(See Figure 4-45 and 4-46).
1. Remove the following screw securing the touch pad/fingerprint sensor board.
2. Peel the insulator and release the LED cable.
3. Remove the touch pad/fingerprint sensor board from the cover assembly.
QOSMIO G40 Maintenance Manual (960-632)
Downloaded from LpManual.com Manuals
• M2.5×4B
FLAT HEAD screw
Insulator
LED board cable
Figure 4-45 Removing the touch pad/fingerprint sensor board
4 Replacement Procedures
×1
Insulator
M2.5x4B FLAT HEAD
Touch pad/fingerprint sensor board
[CONFIDENTIAL]
4-61
Advertisement
Chapters
Table of Contents
Troubleshooting
