4 Replacement Procedures
4.25 Sound board/Microphone harness
Removing the Sound board/Microphone harness
To remove the sound board/microphone harness, follow the steps below and refer to Figure
4-47.
1. Peel off the glass tape.
2. Remove the following screws and sound board/microphone harness from the slot.
•
M2.5×4B
3. Disconnect the microphone harness from the connector CN6050 on the sound board.
4. Disconnect the sound board FFC from the connector CN9630 on the sound board.
Sound board FFC
Glass tape
M2.5x4B FLAT HEAD
CN6050
Microphone
harness
Figure 4-47 Removing the sound board/microphone harness
4-74
[CONFIDENTIAL]
FLAT HEAD screw
M2.5x4B FLAT HEAD
CN9630
Sound board
4.25 Sound board/Microphone harness
×2
TECRA M10 Maintenance Manual (960-685)