Touch Pad/Fingerprint Sensor Board - Toshiba TECRA A11 Series Maintenance Manual

4.14 Touch pad/Fingerprint sensor board

Removing the Touch pad/Fingerprint sensor board
To remove the touch pad/fingerprint sensor board, follow the steps below and refer to Figure
4-26 to 4-28.
1. Turn up the insulator (TPAD LOW INSULATOR) and remove the following screws.

M2.03C
2. Peel off the acetate tape.
3. Disconnect the FS board FFC, touch pad button FFC and dual button FFC from
the connector CN9650 and CN3240 on the fingerprint sensor board and connector on
the touch pad.
NOTE: In models without a dual button, there is no dual button FFC.
FS board FFC
Dual button FFC
M2.0x3C
S-THIN HEAD
M2.0x3C S-THIN HEAD
TECRA A11/S11/P11 Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 4-45
S-THIN HEAD screw
CN9650
CN3240
Figure 4-26 Removing the touch pad (1)
4
Acetate tape
M2.0x3C S-THIN HEAD
Insulator
(TPAD LOW
INSULATOR)
Touch pad
button FFC