Enable Auditdump - HP NonStop TMF Programming Manual

Commands and Responses

ENABLE AUDITDUMP

The ENABLE AUDITDUMP command permits an audit dump process to resume
execution after it has been suspended by the DISABLE AUDITDUMP command,
allowing the process to dump audit trail files once again.
Command Syntax
For information on the tokens present in the command and response buffers, see the
SPI Programming Manual.
Command
ZTMF-CMD-Enable
Object Type
ZTMF-OBJ-AuditDump
Tokens in Command Buffer
ZTMF-TKN-AuditTrailId
Tokens in Response Buffer
None.
Tokens in Command Buffer
ZTMF-TKN-AuditTrailId
specifies the audit trail associated with the audit-dump process to resume
execution. This token is required; only one occurrence is allowed. The following
values are valid:
ZTMF-VAL-Mat
ZTMF-VAL-Aux01
ZTMF-VAL-Aux02
. . .
ZTMF-VAL-Aux015
HP NonStop TMF Management Programming Manual—540140-008
token-type ZSPI-TYP-Enum.
Master audit trail
Auxiliary audit trail #1
Auxiliary audit trail #2
Auxiliary audit trail #15
5-88
ENABLE AUDITDUMP