Inserting The Server Into A Rack - HP Integrity cx2600 Maintenance Manual

Figure 7-1 Chassis Ground Lug
chasgndlug
5. If the server is slide-mounted, slowly pull the chassis forward (or push from the rear) to
extend the chassis from the rack. The server is fully extended when the rail clips are locked
in place. Do not extend tray-mounted servers. Tray-mounted servers are not locked in place
and can fall if extended from the rack.
6. Disengage the slides or mounting hardware and take the server to a static-free work station.

Inserting the Server Into a Rack

To insert the server into a rack, follow these steps:
WARNING!
kilograms (50 lbs). Serious injury can result if this warning is not observed.
1. Engage the sever slides or mounting kit.
2. Slide the server inward and push the server into the rack until it is in position.
3. Connect the server cables to the rear-panel connectors.
4. Connect the rack or facility ground cable to the chassis ground lug
5. Replace or tighten the screws that fasten the server to the rack.
116 Removing and Replacing Components
Do not attempt to lift the server alone. The server can weight as much as 22.7
Chassis
Ground
Lug
(Figure 7-1).