Removing The Top Cover - HP Integrity cx2600 Maintenance Manual

Removing the Top Cover

To remove the top cover, follow these steps:
WARNING!
remove the server top cover without first turning off and disconnecting power. Always replace
the top cover before turning the system on.
1. Power off and disconnect system power. Disconnect power at the DC source end of the
power cables, using the disconnect device that is part of the rack or facility power system.
2. Slide the server out from the rack until it stops. See
(page 22).
3. Remove the server from the rack and place it on an ESD-protected work surface. See
"Removing the Server From a Rack" (page
4. Use the ACX-15 Torx screwdriver to loosen the captive screw that holds the top cover in
place.
Hazardous voltages are present within the server when power is applied. Do not
"Accessing a Rack-Mounted Server"
23).
Installing the Front Grill and Top Cover 29