Removing And Replacing The System Board; Removing The System Board - HP Integrity cx2600 Maintenance Manual

2. Locate the system battery on the system board
CAUTION:
battery just high enough to clear the battery holder. Failure to heed this warning can result
in damage to the clip.
3. Lift the retaining clip and set the new battery in place. Reposition the retaining clip to secure
the battery.
NOTE:
installed with the + sign facing up.

Removing and Replacing the System Board

The system board is removed through the top of the chassis.
WARNING!
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
follow ESD safety precautions can result in damage to the server.
Figure 7-46 System Board

Removing the System Board

To remove a system board, follow these steps:
Do not overstress the battery retaining clip. This clip is easily broken. Lift the
The positive terminal of the battery is designated by the + sign. The battery is
Ensure that the system is powered off and all power sources are disconnected
Observe all ESD safety precautions while performing this procedure. Failure to
(Figure 7-45).
Removing and Replacing the System Board 163