Installing The Front Grill And Top Cover; Removing The Front Grill; Installing The Front Grill - HP Integrity cx2600 Maintenance Manual

13. Install the terminal barrier strip cover (removed in step 11). Hang the cover on the upper
tabs and snap the cover into place.
14. Route the power cable through the power supply cable clamp and tighten the two knurled
knobs to secure the cable in place.
15. Connect the power cable to the DC power source.

Installing the Front Grill and Top Cover

CAUTION:
server susceptible to electromagnetic interference (EMI) and overheating problems, which can
result in system failure. Keep the front grill and top cover in place during normal operation.
Observe all electrostatic discharge (ESD) safety precautions while performing this procedure.
Failure to follow ESD safety precautions can result in damage to the server.
Figure 3-6 Removing the Front Grill

Removing the Front Grill

You must remove the front grill for access to the front mounted fans or the optical drive. To
remove the front grill, perform the following steps:
To remove the front grill, follow these steps:
1. Use the ACX-15 Torx screwdriver to loosen the five captive screws that secure the grill to
the chassis.
2. Pull the grill from the front of the server chassis.

Installing the Front Grill

To install the front grill, follow these steps:
1. Hold the grill against the front of the server chassis in mounting position.
2. Tighten the five captive screws to secure the grill to the server chassis
28 Installing Additional Components
Operation of the server without the front grill and top cover in place makes the
(Figure 3-6).