Removing And Replacing The Led Status Panel; Removing The Led Status Panel - HP Integrity cx2600 Maintenance Manual

6. Secure the card in the card cage using the retaining screws provided.
7. Connect the cables to the card sockets.

Removing and Replacing the LED Status Panel

The LED status panel can be removed from the front of the server chassis. It is mounted together
with the CD/DVD optical drive assembly.
WARNING!
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
follow ESD safety precautions can result in damage to the server.

Removing the LED Status Panel

To remove the LED status panel, follow these steps:
1. Power off and disconnect system power. Disconnect power at the DC source end of the
power cables, using the disconnect device that is part of the rack or facility power system.
2. Remove the front grill. See
3. Remove the two noncaptive screws (M3 x 6mm long pan T15/slot square cone stainless steel)
that secure the CD/DVD deck and LED status panel assembly to the server chassis. Pull the
entire assembly from the chassis.
Figure 7-17 Removing the CD/DVD Deck and LED Status Panel Assembly
4. Disconnect the cable from the small connector on the LED status panel.
136 Removing and Replacing Components
Ensure that the system is powered off and all power sources are disconnected
Observe all ESD safety precautions while performing this procedure. Failure to
"Removing and Replacing the Front Grill" (page
chasdvdxtnd
Deck/Panel Assembly
Mounting Screws
122).
CD/DVD Deck
Assembly