Removing A Processor - HP Integrity cx2600 Maintenance Manual

Figure 7-27 Processors in Server Chassis (Top Cover Removed)
CPU 0
CPU 1
A tool kit is provided with replacement processors. An IPF CPU tool kit is required for successful
completion of these procedures.

Removing a Processor

WARNING!
from the server prior to removing or replacing components.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning could result in personal injury or damage to equipment.
CAUTION:
to follow ESD safety precautions could result in damage to the server.
To remove a processor, proceed as follows:
1. If rack-mounted, extend the server out from the rack until it stops. See
When the Server Is in a Rack" (page
2. Turn off the system. Disconnect all external cables.
3. Remove the server from the rack and place it on an ESD-protected work surface. See
"Removing the Server From a Rack" (page
4. Remove the chassis top cover. See
5. Remove the processor airflow guide. See
6. Disconnect the CPU power module cable.
148 Removing and Replacing Components
chastop2cpus
Ensure the system is powered down and all power sources have been disconnected
Observe all ESD safety precautions while performing processor removal. Failure
114).
115).
"Removing and Replacing the Top Cover" (page
"Removing the Processor Airflow Guide" (page
F
R
O
N
T
"Installing Components
123).
128).