Gigabit Lan Leds - HP Integrity cx2600 Maintenance Manual
Hp integrity cx2600 operations and maintenance guide
Hide thumbs
Also See for Integrity cx2600:
- Installation instructions manual (10 pages) ,
- Manual (46 pages) ,
- Firmware update manual (15 pages)
Table of Contents
Advertisement
Figure 4-2 Rear Panel LEDs
MP LAN LEDs
1
Gigabit LAN LEDs
2
System Management
3
LAN (10/100) LEDs
Locator Button LEDs
4
Table 4-4 Rear Panel LED Definitions
LED/Button
MP Self Test LED (top)
MP 10BT LED (2nd from top)
MP 100BT LED (2nd from bottom)
MP LAN Standby Power LED
(bottom)
Gigabit LAN Gbit LED (top)
Gigabit LAN 100 Mbit LED (2nd
from top)
Gigabit LAN Link LED (2nd from
bottom)
Gigabit LAN Activity LED
(bottom)
System Management LAN
Activity LED
System Management LAN Speed
LED
Locator
Power Supply Fault LED
5
Power Supply DC Out
6
LED
Power Supply DC In LED
7
Color
Green
When off, self test is not active. When lit, the MP is running self test.
Green
When off, no link detected or 100 BT link is active. When flashing,
indicates 10 BT LAN activity. When lit steady, indicates that 10 BT link
has been established.
Green
When off, no link detected or 10 BT link is active. When flashing,
indicates 100 BT LAN activity. When lit steady, indicates that 100 BT
link has been established.
Green
When off, standby power is not applied to MP LAN circuits. When lit,
power is connected to the server but the server is not on.
Green
When off, no 1000 Mbps link has been detected. When lit, port is linked
at 1000 Mb/s.
Green
When off, no 100 Mbps link has been detected. When lit, port is linked
at 100 Mb/s.
Green
When off, no 10 Mbps link has been detected. When lit, port is linked
at 10 Mb/s.
Green
When off, no LAN activity has been detected. When lit, port is linked
at 1000 Mb/s.
Green
When lit, shows that port is linked.
Green
When off and Activity LED is lit, shows that port is linked to 10 Mb
LAN. When lit, shows that port is linked to 100 Mb LAN.
Blue
Lit by pressing the associated button, by pressing the corresponding
button on the front panel, or by command from a remote location.
Identifies one server among many. Also tests for a running BMC on
the system board.
Power Supply Fault LED
8
Power Supply DC Out
9
LED
Power Supply DC In LED
10
Description
Troubleshooting Using LED Indicators
61
Advertisement
Table of Contents
Troubleshooting
