Removing And Replacing The Cd/Dvd Optical Drive; Removing The Optical Drive; Installing The Optical Drive; Removing And Replacing The Hard Drive Backplane Assembly - HP Integrity cx2600 Maintenance Manual

Removing and Replacing the CD/DVD Optical Drive

You can remove the optical drive from the front of the server chassis.
WARNING!
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION:
follow ESD safety precautions can result in damage to the server.

Removing the Optical Drive

The CD/DVD optical drive is accessible from the front of the server chassis. It is mounted in a
sheet metal deck that also houses an LED status panel printed wiring board. To remove the
optical drive, follow these steps:
1. Power off and disconnect system power. Disconnect power at the DC source end of the
power cables, using the disconnect device that is part of the rack or facility power system.
2. Remove the front grill. See
3. Remove the two screws (M3 x 6mm long pan T15/slot square cone stainless steel) that secure
the CD/DVD deck and LED status panel assembly to the server chassis
the entire assembly from the server chassis.
4. Disconnect the cables from the large connector of the DVD drive and from the small connector
of the LED status panel.
5. Remove the LED status panel board. See
NOTE:
the LED status panel, constitutes the CD/DVD element of the server.

Installing the Optical Drive

To install an optical drive, follow these steps:
1. Install the LED status panel on its standoffs located on the top surface of the sheet metal
deck. See
2. Connect the cables to the large connector of the DVD drive and to the small connector of
the LED status panel.
3. Position the DVD deck or LED status panel deck assembly into the front of the chassis and
slide it into the slots above the screw mount.
4. Fasten the two noncaptive screws (M3 x 6mm long pan T15/slot square cone stainless steel)
securing it to the server chassis

Removing and Replacing the Hard Drive Backplane Assembly

The SCSI hard drive backplane is located on the lower chassis deck. You can see the SCSI hard
drive backplane from the rear of the chassis when you remove the rear fan module. Dismantling
138 Removing and Replacing Components
Ensure that the system is powered off and all power sources are disconnected
Observe all ESD safety precautions while performing this procedure. Failure to
"Removing and Replacing the Front Grill" (page
The entire sheet metal deck with the optical drive element installed in it, minus
"Installing the LED Status Panel" (page
"Removing the LED Status Panel" (page
137).
(Figure 7-17).
122).
(Figure 7-17). Pull
136).