Removing A Processor - HP Integrity cx2600 Maintenance Manual

Figure 3-12 Processors in Server Chassis (Top Cover Removed)

Removing a Processor

To remove a processor, proceed as follows:
1. If rack-mounted, extend the server out from the rack until it stops. See
Rack-Mounted Server" (page
WARNING!
disconnected from the server prior to removing or replacing components.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is in the off position.
Failure to observe this warning could result in personal injury or damage to equipment.
2. Turn off the system. Disconnect all external cables.
3. If desired, remove the server from the rack and place it on an ESD-protected work surface.
See "Removing the Server From a Rack" (page
4. Remove the chassis top cover. See
CAUTION:
to follow ESD safety precautions could result in damage to the server.
5. Remove the processor airflow guide. See
6. Disconnect the CPU power module cable.
38 Installing Additional Components
22).
Ensure the system is powered down and all power sources have been
"Removing and Replacing the Top Cover" (page
Observe all ESD safety precautions while performing processor removal. Failure
115).
"Removing the Processor Airflow Guide" (page
"Accessing a
123).
128).