Table of Contents
Advertisement
SERVICE MODE
The 'Identification' screen gives in-
formation concerning :
- Projector address. To change the
address of your projector, contact
a qualified service technician.
- Software version.
- Configuration.
Possible installations :
* Front-ceiling
* Front-table
* Rear-ceiling
* Rear-table
- Baud rate PC : transfer speed for communication with an IBM PC (or compat-
ible) or MAC. The baud rate of the projector must be the same as the baud rate
of the connected computer. When there is a difference, contact a qualified
service technician to make the appropriate changes.
- Text ON/OFF
Indicates in operational mode if the bar scale and number indicator will be
displayed and if warnings and failures will be displayed.
ON : displayed
OFF : not displayed
The status can be changed by pressing the 'TEXT' key once on the RCU.
- Serial no. : indicates the fabrication number of the projector. This number can
be useful when calling for technical assistance.
Total Run Time
Highlight 'Total Run Time' with the
control disk and press ENTER to
display the amount of time the pro-
jector has played since its first start
up at the factory.
R5975228 BARCOVISION 701 MULTIMEDIA 070597
V 701 MULTIMEDIA
P ro j. a d dr e s s : 00 1
S of t. V er sion : 5 .0 0
Con f ig . : Ceilin g
B a u d r a t e P C : 9 6 0 0
T e x t : O N
S e r ial No . : 1 03 5 9 8 5 2
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Select with
then <ENTER>
<EXIT> to return.
ENTER gives the selected item.
EXIT returns to the Service mode menu.
ADJUST returns to the Operational mode.
front
or
9-5
Advertisement
Table of Contents
