Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the
female power connector into the male connector at the front of the projector.
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the
'stand by mode', depending on the position of the 'power up' dip switch on the
controller unit. This DIP switch is set during installation by a qualified technician.
If you want to change this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
Leds on the front plate of the projector
3-2
POWER CONNECTION
See installation instructions before
con nectin g to t he sup ply
V NOM 1 20 / 23 0 Volt
I MAX
F REQ
O F F O N
R5975238 BARCOVISION 701 MULTIMEDIA 070497
See installation instructions before
connecting to t he supply
V NO M 120/230 Volt
I MAX
5/2. 5 A MP
FR EQ
60/50 Hz
O F F O N
5/ 2. 5 AM P
60 / 50 Hz