How to start up ?
To select Identification :
1. Push the cursor key é or ê to highlight Identification (menu 1).
2. Press ENTER to select.
The identification screen will be displayed (menu 2).
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
COMMON ADDRESS : 0
BARCO LOGO
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Total Run Time
What can be displayed ?
The total run time since the first start up can be displayed.
Note
All projectors leave the factory after a burn-in period of approximately 100 hours.
How to start up ?
To select Total Run Time :
1. Push the cursor key é or ê to highlight Total Run Time (menu 1).
2. Press ENTER to activate.
The amount of time the projector has played since its first start up at the factory will be displayed in a text box (menu 2).
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
COMMON ADDRESS : 0
BARCO LOGO
Select with é or ê
then <ENTER>
<EXIT> to return.
menu 1
Change password
What can be done ?
The password code (4 digits) can be changed to a new one.
This item is password protected. First the actual password should be entered before continuing.
Note
Password function is only active if the jumper on the controller is in the 'ON' position.
5976066 BARCOCINE 7 011299
CINE 7
Proj. address : 001
Soft. Version : 6.00
Config. : Ceiling
Front
Baudrate PC : 9600
Text : ON
Serial No. : 103589552
menu 2
RUN TIME
110 h
menu 2
Service Mode
8-3