Table of Contents
Advertisement
APPENDIX A : BATTERY REPLACEMENT IN THE RCU
Battery replacement in the RCU.
Remove the battery cover on the backside of the remote
control by pushing the indicated handle a little to the
bottom of the RCU. Lift up the top side of the cover at the
same time (fig. 1).
Remove the battery from the compartment and discon-
nect the contact plate (fig. 2).
Connect a new 9 V battery (type E-block, e.g. 6F22S
or equivalent) to the contact plate.
Insert the battery back into the compartment and put
the cover back.
Attention : when a new battery is installed, the projector
address must be reprogrammed before using the
RCU.
R5975238 BARCOVISION 701 MULTIMEDIA 070497
Contact
plate
Battery
fig.2
310a . DRW
fig.1
A-1
Advertisement
Table of Contents
