Table of Contents
Advertisement
Total Run Time
Highlight 'Total Run Time' with the control disk and press ENTER to
display the amount of time the projector has played since its first start
up at the factory.
ENTER gives the selected item.
EXIT returns to the Service mode menu.
ADJUST returns to the Operational mode.
Note : all projectors leave the factory after a burn-in period of
approximately 100 hours.
Change password
This item is password protected.
Highlight 'Change Password' with the control disk and press ENTER .
ENTER will display the selected item.
EXIT will return to the Path Selection main menu.
ADJUST will return to the Operational mode.
The current password is displayed. The new password must consist
of 4 digits between 0 and 9. Push the control disk to the left or to the
right to select the digits to be changed. Use the numeric keys to enter
the new digits.
Press ENTER to save the new password. Before saving the new
password, a confirmation screen will be displayed.
Press EXIT to return to the Projector Set-up menu without saving the
new password.
When the displayed password is correct, press ENTER to save.
If not correct, press EXIT to cancel the saving.
ENTER saves the entered password.
EXIT returns without saving.
Change Language
The 'Change Language' function offers the possibility to change the
language of the screen menus to :
- English
- Spanish
- French
- German
Highlight 'Change Language' with the control disk and press ENTER .
ENTER selects the Change language menu.
EXIT returns to the Service menu.
Push the control disk up or down to select the desired language and
press ENTER to change the language.
5975977 BARCODATA 708 260597
PROJECTOR SET-UP
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Select with
or
then <ENTER>
<EXIT> to return.
PASSWORD
Enter new password :
0 0 0 0
Use
and
to select,
and reprogram
with numeric keys.
CHANGE PASSWORD
<ENTER> to confirm
<EXIT> to return
Password will be
reprogrammed as xxxx
<ENTER> to confirm
<EXIT> to cancel
PROJECTOR SET-UP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
Select with
or
then <ENTER>
<EXIT> to return.
Service Mode
IDENTIFICATION
TOTAL RUN TIME
BARCO LOGO
Select with
or
then <ENTER>
<EXIT> to return.
LANGUAGE
ENGLISH
ESPAÑOL
FRANCAIS
DEUTSCH
Select with
or
then <ENTER>
<EXIT> to return.
7 - 3
Advertisement
Table of Contents
