Using Remote Programming; Changing The Dynamic Extension Express Settings - Mitel 5320 User Manual

Using Remote Programming

If the Configuration Assistant feature is enabled for your system, Mitel recommends that you
use Configuration Assistant instead of the Remote Programming feature described in this
section. Configuration Assistant offers an enhanced, voice guided configuration portal that
provides easy-to-use, remote access to the Call Forwarding, Dynamic Extension Express, and
DND features. See
To use Remote Programming to access these features from another system phone or an
external phone, follow the instructions in this section.
NOTE

Changing the Dynamic Extension Express Settings

See "Using Dynamic Extension Express" on
Extension Express.
To enable Dynamic Extension Express using Remote Programming:
1. Do one of the following:
2. Dial 359.
3. Enter your extension number.
4. Enter your station passcode followed by #. See
5. Dial 363 (Dynamic Extension Express On).
To disable Dynamic Extension Express using Remote Programming:
4.
Mitel ® 5320/5330/5340 IP Phone User Guide – Release 5.0, April 2013
page 60 for using Configuration Assistant.
A Direct Inward System Access (DISA) number is required to use Remote
Programming from an external phone. Contact your system administrator for more
information.
•
Call your DISA number (provided by the system administrator). If necessary, enter
your DISA security code.
•
Use any phone on the system.
passcode for your extension.
Follow steps 1 - 4 above, dial 362 (Dynamic Extension Express Off), and then hang up.
This feature may or may not be enabled for your system.
4
page 49 for more information about Dynamic
page 60 for details on setting up a
Call Features
Page 63