Using A Cordless Device As A Remote Control; Using The Mute Key On A Cordless Device; Using The Volume Keys On Cordless Device; Alerting Tones And Leds - Mitel 5320 User Manual

Cordless Devices

Using a Cordless Device as a Remote Control

When not being used to talk, the cordless handset/headset buttons can act as a remote control
device to change display contrast, volume, and mute settings on the host IP phone. For
example, in a remote handsfree conference setting, you can use the Volume and Mute buttons
on a cordless device to adjust speaker levels and mute the microphone on an IP phone that is
not within his reach.

Using the Mute Key on a Cordless Device

When using a Mitel-branded cordless accessory, the Mute key on the cordless accessory is
synchronized with the Mute key on your phone. Pressing the Mute key on either the phone or
the accessory also controls the Mute function on the other device.
There is no synchronization between a third-party Bluetooth headset mute control (if one is
available) and your phone Mute key. The procedure for muting a Bluetooth headset depends on
the headset manufacturer. Some headsets have a mute control and some do not. You can,
however, use the Mute key on your phone to mute a conversation on any type of Bluetooth
headset.

Using the Volume Keys on Cordless Device

When using a Mitel-branded cordless accessory, the Volume keys on the cordless accessory
are synchronized with the Volume keys on your phone. Pressing the Volume keys on either the
phone or the accessory also controls the Volume function on the other device.
When using a third-party Bluetooth headset, the volume control on the headset (if one is
available) is not synchronized with the Volume keys on your phone. Pressing the Volume keys
on the phone does not change the headset volume.

Alerting Tones and LEDs

The cordless devices provide the following alerting tones:
Mute key on cordless device ON/OFF
Mute key on phone ON/OFF
Low battery (within 10 minutes left)
Low battery (within 2 minutes left)
Out of range
NOTES
Page 84
Feature
Audio indications are heard in the handset only when it is in use, and may interrupt
voice transmission.
If you are out of range for more than 10 seconds, any call that is in progress is
dropped and not recovered.
Mitel ®
Function
Two-pitch tone occurs immediately. Reminder tone
occurs 30 seconds after activation and then
regularly until deactivated
No immediate tone. Reminder tone occurs 30
seconds after activation and then regularly until
deactivated.
Three beeps and 20 second pause repeated three
times.
Three rapid beeps and 1.5 second pause repeated
three times.
Repetitive 3-pitch tone until you are back in range.
5320/5330/5340 IP Phone User Guide – Release 5.0, April 2013