Mitel 5320 User Manual page 106

Cordless Devices
Cordless Headset Alerting Tones and LEDs
The cordless headset provides the following alerting tones:
Mute ON/OFF
Mute key on Phone ON/OFF
Low battery (within 10 minutes left) 3 beeps and 20 second pause
Low battery (within 2 minutes left)
Out of range
There are two LEDs associated with the cordless headset:
•
•
The handset is blinking, when the LED is on and off for an equal amount of time. The handset is
winking, when the LED is on for a short period of time and off for a longer period of time.
Led Color
Blue (on
headset)
Green (on
cradle)
Page 90
Blue – Indicates the operational status of the headset
Green – Indicates the status of the electrical charge of the battery
LED State
Solid
Blinking
Winking
Solid for 2 seconds
Solid
Blinking
Winking
Off
2-pitch tone occurs immediately. Reminder tone occurs
30 seconds after activation and then regularly until
deactivated.
No immediate tone. Reminder tone occurs 30 seconds
after activation and then regularly until deactivated.
3 rapid beeps and 1.5 second pause
Repetitive 3-pitch tone until you are back in range. Note:
If you are out of range for more than 10 seconds, any call
that is in progress is dropped and not recovered.
Headset microphone is muted.
Headset is in pairing mode.
Active audio path between Headset and
Module.
Indicates one of the following:
•
Pairing successful
•
New battery installed
Battery is fully charged.
Battery is charging.
Indicates low voltage when headset is
uncradled.
When headset is cradled, indicates battery is
not charging.
Mitel ® 5320/5330/5340 IP Phone User Guide – Release 5.0, April 2013
Indicates