Using The Cordless Devices Application; Viewing Cordless Module Information - Mitel 5320 User Manual

Cordless Devices

Using the Cordless Devices Application

The Cordless Devices Application provides access to module information and pairing for
handset or headsets.
To access the Cordless Devices Application, do one of the following:
•
•
For information about programming feature keys, see
NOTE

Viewing Cordless Module Information

You can use the Cordless Module Application to view protocol, firmware, and hardware
information about the module.
To view cordless module information:
1.
2.
3.
Low Battery Level
When the battery of a Mitel cordless device reaches a near-critical level, the phone displays a
warning. Until the battery is recharged (or until it becomes fully discharged), the warning is
repeated at each new call made using the Prime Line. To continue with a call while charging the
cordless accessory, switch to speakerphone and then cradle the cordless accessory.
Enabling/Disabling Auto-Connect on a Bluetooth Headset
When pairing a Bluetooth headset with the Bluetooth Module installed on your phone, you are
given the option to enable the Auto-Connect feature-a feature whereby, if a previously paired
Bluetooth device comes into range of the module, it will automatically be connected.
If desired, you can turn this feature on or off using the Cordless Devices application. You should
turn on the feature if you are the only user of the phone. If you share the phone, as is
sometimes the case in a call center environment, you should turn off the feature.
To turn the Auto-Connect feature on or off:
1.
2.
3.
Connecting/Disconnecting a Bluetooth Headset
You can use the Cordless Device Application to connect or disconnect any Bluetooth headset
that requires manual connection.
To connect or disconnect a Bluetooth headset:
1.
Page 92
Press (Applications), and then press Cordless Devices.
Press a feature button (key) you have programmed as the Cordless Devices Application
key.
When the pairing button on the Cordless Module is pressed, or when the battery
level of a cordless accessory is critically low, the IP phone will automatically open
the Cordless Devices Application.
Press (Applications), and then press Cordless Devices.
Press Cordless Module Info. Device information appears on the screen.
Press Close to exit.
Access the Cordless Devices Application.
Press the desired Bluetooth headset, and then select Auto-connect (On) or Auto-
connect (Off) to toggle the feature to the desired setting.
Press Close to exit.
Access the Cordless Devices Application.
page
Mitel ® 5320/5330/5340 IP Phone User Guide – Release 5.0, April 2013
30.