Cisco TrustSec Configuration Manual page 189

Chapter 7 Cisco TrustSec Command Summary
timer (cts do1x interface submode)
To set the dot1x authentication timer, use the timer authentication CTS dot1x interface configuration
command. Use the no form of the command to disable dot1x reauthentication.
Syntax Description reauthentication seconds
Defaults
The default period is 86,400 seconds (24 hours).
Command Modes
CTS dot1x interface configuration submode (config-if-cts-dot1x)
Supported User Roles Administrator
Command History Release
12.2(33) SXI
Usage Guidelines
Use the timer reauthentication command to configure a dot1x reauthentication period if the
authentication server does not specify a period. If no reauthentication period is specified, the default
period is 86,400 seconds. To disable dot1x reauthentication, use the no form of the command or specify
a period of 0 seconds. Use the default timer reauthentication command to restore the default value.
Examples
The following example sets the 802.1X reauthentication period for 48 hours (17, 2800 seconds):
router# config t
router(config)# interface gigabitEthernet 6/1
router(config-if)# cts dot1x
router(config-if-cts-dot1x)# timer reauthentication 172800
Related Commands Command
show cts interface
sap (cts dot1x interface
submode)
propagate (cts dot1x
submode)
OL-22192-01
[no] timer reauthentication seconds
Modification
This command was introduced on the Catalyst 6500 Series Switches.
Description
Displays Cisco TrustSec states and statistics per interface.
Configures CTS SAP for dot1x mode.
Enables/disables SGT propagation in dot1x mode.
(0–2147483) Timer in seconds. Enter 0 to disable dot1x
reauthentication.
timer (cts do1x interface submode)
Cisco TrustSec Configuration Guide
7-103