Cisco TrustSec Configuration Manual page 128

cts sxp
Examples The following example shows how to enable SXP and configure the SXP peer connection on SwitchA,
a speaker, for connection to SwitchB, a listener:
SwitchA# configure terminal
SwitchA#(config)# cts sxp enable
SwitchA#(config)# cts sxp default password Cisco123
SwitchA#(config)# cts sxp default source-ip 10.10.1.1
SwitchA#(config)# cts sxp connection peer 10.20.2.2 password default mode local speaker
The following example shows how to configure the SXP peer connection on SwitchB, a listener, for
connection to SwitchA, a speaker:
SwitchB# configure terminal
SwitchB(config)# cts sxp enable
SwitchB(config)# cts sxp default password Cisco123
SwitchB(config)# cts sxp default source-ip 10.20.2.2
SwitchB(config)# cts sxp connection peer 10.10.1.1 password default mode local listener
Related Commands Command
show cts sxp
Cisco TrustSec Configuration Guide
7-42
Chapter 7
Description
Displays status of all SXP configurations.
Cisco TrustSec Command Summary
OL-22192-01