Cisco TrustSec Configuration Manual page 141

Chapter 7 Cisco TrustSec Command Summary
default (cts dot1x interface configuration submode)
To restore any of the cts dot1x configurations to their default values, use the default command in CTS
dot1x interface configuration submode.
Syntax Description propagate sgt
sap
timer
Defaults
There is no default for this command.
Command Modes CTS dot1x interface configuration submode (config-if-cts-dot1x)
Supported User Roles Administrator
Command History Release
12.2(50) SY
Examples The following example re-enables SGT propagation:
router# config t
router(config)# interface gigabit 6/1
router(config-if)# cts dot1x
router(config-if-cts-dot1x)# default propagate sgt
Related Commands Command
propagate (cts dot1x
submode)
sap (cts dot1x interface
submode)
timer (cts do1x interface
submode)
OL-22192-01
default propagate sgt
default sap
default timer reauthentication
Restores default to enabled for propagate sgt.
Restores default to sap modelist gcm-encrypt null.
Restores default 86,400 seconds for the dot1x reauthentication period.
Modification
This command was introduced on the Catalyst 6500 Series Switches.
Description
Enables/disables SGT propagation in dot1x mode.
Configures CTS SAP for dot1x mode.
Configures the CTS timer.
default (cts dot1x interface configuration submode)
Cisco TrustSec Configuration Guide
7-55