Cisco TrustSec Configuration Manual page 100

default timer reauthentication (cts interface)
default timer reauthentication (cts interface)
Use the default timer reauthentication command in CTS interface configuration mode to reset the CTS
dot1x reauthentication timer to the default value.
Syntax Description timer reauthentication Sets the CTS reauthentication timer to the default values.
Defaults
3600 seconds
Command Modes CTS interface configuration (config-if-cts-dot1x)
Supported User Roles Administrator
Command History Release
12.2(33) SXI
Usage Guidelines The default value of the CTS reauthentication timer is the global dot1x reauthentication default (3600
seconds). When this timer expires, the device reauthenticates to the CTS network (NDAC).
Examples The following example resets the CTS reauthentication timer to the global default values:
Router # configure terminal
Router(config)# interface gigabitEthernet 3/1
Router(config-if)# cts dot1x
Router(config-if-cts-dot1x)# default timer reauthentication
Related Commands Command
cts dot1x
timer reauthentication
(cts interface)
show cts interface
show dotx interface
Cisco TrustSec Configuration Guide
7-14
default timer reauthentication
Modification
This command was introduced on the Catalyst 6500 series switches.
Description
Enters CTS dot1x interface configuration mode (config-if-cts-dot1x).
Sets the CTS reauthentication timer.
Displays CTS interface status and configurations.
Displays IEEE 802.1x configurations and statistics.
Chapter 7 Cisco TrustSec Command Summary
OL-22192-01