Cisco TrustSec Configuration Manual page 102

cts layer3
cts layer3
Use the cts layer 3 interface configuration command to enable CTS Layer3 Transport gateway
interfaces, and to apply exception and traffic policies to them.
Syntax Description ipv4 | ipv6
policy
trustsec forwarding
Defaults CTS Layer3 Transport is not enabled by default.
Command Modes Interface configuration (config-if)
Supported User Roles
Administrator
Command History Release
12.2(50) SY
Usage Guidelines Use the cts policy layer3 global configuration command to specify which traffic and exception
commands to apply to the CTS Layer3 gateway. Use the cts layer3 interface configuration command to
enable the CTS Layer3 gateway interface and to apply the traffic and exception policies. See
layer3
Examples The following example enables a CTS Layer3 Transport gateway interface:
Router# config t
Router(config)# interface gigabitEthernet 6/1
Router(config-if)# cts layer3 ipv4 trustsec forwarding
Router(config-if)# cts layer3 ipv4 trustsec
Router(config-if)# cts layer3 ipv4 policy
Related Commands Command
cts policy layer3
show cts policy layer3
Cisco TrustSec Configuration Guide
7-16
cts layer3 {ipv4 | ipv6} {policy | trustsec forwarding}
Specify IPv4 or IPv6
Applies the traffic and exception policies on the gateway interface.
Enables CTS Layer3 Transport on the gateway interface.
Modification
This command was introduced on the Catalyst 6500 Series Switches.
for further information on traffic and exception policies.
Description
Specifies traffic and exception policies for CTS Layer 3 Transport.
Displays the name of traffic and exception polices used for CTS Layer3
Transport configurations.
Chapter 7 Cisco TrustSec Command Summary
cts policy
OL-22192-01