Cisco TrustSec Configuration Manual page 101

Chapter 7 Cisco TrustSec Command Summary
timer reauthentication (cts interface)
Use the timer reauthentication command in CTS interface configuration mode to set the
reauthentication timer. Use the no form of the command to disable the timer.
Syntax Description reauthentication seconds
Defaults
None
Command Modes CTS interface configuration (config-if-cts-dot1x)
Supported User Roles Administrator
Command History Release
12.2(33) SXI
Usage Guidelines This command sets the TrustSec reauthentication timer. When this timer expires, the device
reauthenticates to the CTS network (NDAC).
Examples The following example sets the reauthentication timer to 44 seconds:
Router(config-if-cts-dot1x)# timer reauthentication 44
Related Commands Command
cts dot1x
default timer
reauthentication (cts
interface)
show cts interface
show dotx interface
OL-22192-01
[no] timer reauthentication seconds
Modification
This command was introduced on the Catalyst 6500 series switches.
Description
Enters CTS dot1x interface configuration mode (config-if-cts-dot1x).
Resets the CTS dot1x reauthentication timer to the default value.
Displays CTS interface status and configurations.
Displays IEEE 802.1x configurations and statistics.
Sets the reauthentication timer.
timer reauthentication (cts interface)
Cisco TrustSec Configuration Guide
7-15