Cisco TrustSec Configuration Manual page 148

platform cts
platform cts
To enable the TrustSec egress or ingress reflector use the platform cts global config command. Use the
no form of the command to disable the reflector.
Syntax Description egress
ingress
Defaults The default is no ingress or egress reflector.
Command Modes Global configuration (config)
Supported User Roles Administrator
Command History Release
12.2(50) SY
Examples The following example enables the CTS ingress reflector on a Catalyst 6500 switch:
switch(config)# platform cts egress
The following example disables the CTS ingress reflector on a Catalyst 6500 switch:
switch(config)# no platform cts egress
Related Commands Command
show platform cts reflector
Cisco TrustSec Configuration Guide
7-62
[no] platform cts {egress | ingress}
Specifies the egress TrustSec reflector to be enabled or disabled.
Specifies the ingress TrustSec reflector to be enabled or disabled.
Modification
This command was introduced on the Catalyst 6500 Series Switches.
Description
Displays the status of the Cisco TrustSec reflector mode.
Chapter 7 Cisco TrustSec Command Summary
OL-22192-01