Cisco TrustSec Configuration Manual page 144

default (cts manual interface configuration submode)
default (cts manual interface configuration submode)
To restore any of the cts manual configurations to their default values, use the default command in CTS
manual interface configuration submode.
Syntax Description dynamic identity
policy static sgt
policy propagate sgt
sap
Command Modes CTS manual interface configuration submode (config-if-cts-manual)
Supported User Roles Administrator
Command History Release
12.2(50) SY
Usage Guidelines To restore the CTS manual interface configuration submode parameters to default values, use the default
subcommand.
Examples The following example restores the default dynamic policy and SGT propagation policies of a Catalyst
6500 series switch CTS-enabled interface:
router# config t
router(config)# interface gigbitEthernet 6/1
router(config-if)# cts manual
router(config-if-cts-manual)# default policy dynamic identity
router(config-if-cts-manual)# default propagate sgt
Cisco TrustSec Configuration Guide
7-58
default policy dynamic identity
default policy static sgt
default propagate sgt
default sap
Defaults to the peer policy downloaded from the AAA server.
Defaults to no policy. That is, no SGT is applied to ingress traffic.
Specifies SGT propagation mode of On.
Specifies default SAP values. (GCM-Encrypt, null)
Modification
This command was introduced on the Catalyst 6500 Series Switches.
Chapter 7 Cisco TrustSec Command Summary
OL-22192-01