Bypass A Pt; L## Bypass A Pt; Unbypass A Pt; L## Unbypass A Pt - Bosch D9112B Program Entry Manual

D9112B | Program Entry Guide | 3.0

Bypass a Pt

Default: P
Selection: Blank, E, or P
Bypass a Point [COMMAND] [0]: Bypass points in
Scope
areas within the
where the function is entered (see Cmd Cntr
Assignment). Bypassed points do not respond to faults.
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.

L## Bypass a Pt

Program Record Sheet
Default: See
Selection: Blank or E
Bypass a Point: See Authority Level Selections in the
introduction to the Authority Lvl Assign programming
module for descriptions of selections.

Unbypass a Pt

Default: P
Selection: Blank, E, or P
Unbypass a Point [COMMAND] [0] [0]: Unbypass
points in areas within the
center where the function is entered (see Cmd Cntr
Assignment). When unbypassed, a point can detect
faults and respond according to programming.
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.

L## Unbypass a Pt

Program Record Sheet
Default: See
Selection: Blank or E
Unbypass a Point: See Authority Level Selections in
the introduction to the Authority Lvl Assign
programming module for descriptions of selections.

Reset Sensors

Default: E
Selection: Blank, E, or P
Reset Sensors [COMMAND] [4] [7]: Activate the
Reset Sensors function in areas within the
the command center where the function is entered
(see Cmd Cntr Assignment). See Relays section for
information about Reset Sensors relay activation.
Bosch Security Systems | 2/04 | 74-06145-000-D
User Interface
of the command center
Scope of the command
Scope
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.

L## Reset Sensors

Default:
Selection:
Reset Sensors: See Authority Level Selections in the
introduction to the Authority Lvl Assign programming
module for descriptions of selections.

Relay Control

Default:
Selection:
Relay Control [COMMAND] [5] [4]: Manually
operate relays installed in the D9112 system. This is
a panel-wide function that can be executed from
any command center assigned to an area where the
user has authority. See the D9112 Operation and
Installation Manual for information about optional
relays.
See Command Center Function Selections in the
introduction to the Command Center Functions
programming module for descriptions of selections.

L## Relay Control

Default:
Selection:
Relay Control: See Authority Level Selections in the
introduction to the Authority Lvl Assign programming
module for descriptions of selections.

Remote Program

Default:
Selection:
Remote Programming [COMMAND] [4] [3]:
Initiate Remote Account Manager (RAM) sessions.
This is a panel-wide function that can be executed
from any command center assigned to an area where
the user has authority. Reports concerning the
remote programming session are generated as Area
1 events.
See Command Center Function Selections in the
introduction to the Command Center Functions
of
programming module for descriptions of selections.
See Training Sheet
Blank or E
P
Blank, E, or P
See Program Record Sheet
Blank or E
P
Blank, E, or P
EN | 58