Bosch D9112B Program Entry Manual page 71

D9112B | Program Entry Guide | 7.0
4 There are two ways to use
Keyswitch Maintain: Program
Keyswitch point.
Normal: The area is disarmed
Open: When this point changes from normal to open, the area arms.
Short: A short is a trouble while the area is disarmed.
A short is an alarm while the area is armed.
When this point changes from shorted to normal or open, it restores.
Trouble
Alarm
D279: Program
of an account command center should be programmed to include the D279's area.
Cut the W1 jumper on the D279 to send
Area Parameters and to provide bell control. If the D279's W1 jumper is NOT cut then no
Open
no matter how the D9112 is programmed.
Normal: When this point changes from open to normal, the area arms.
Open: The area is disarmed. The alarm bell silences if an alarm occurred while the area was
armed.
Short: A short is a trouble while the area is disarmed.
A short is an alarm while the area is armed.
When this point changes from shorted to normal or open, it restores but does not send a
Restoral
5 Keyswitch Momentary: Used for Area Arming and Disarming.
programmed 1. Do not connect initiating devices to a Keyswitch point.
N S N: When this point momentarily changes from normal to shorted to normal, it toggles the
armed state of the area.
Open: An open is a trouble while the point is disarmed.
An open is an alarm while the point is armed.
When this point changes from shorted to normal to open, it restores.
Trouble
Trouble
6 Open/Close: Used for Point Arming and Disarming.
Local bells are silenced through the command center.
Normal: The point is armed and sends
YES.
Open: An open is an alarm while the point is armed.
An open is a trouble while the point is disarmed.
Alarm
Short: The point is disarmed and sends
sounding.
Bosch Security Systems | 2/04 | 74-06145-000-D
Point Index
Point Type
Restoral
and reports are not sent if
Restoral
and reports are not sent if
Point Response
Area Close
or report is sent, and alarm bells can only be silenced from a command center,
report.
Restoral
and reports are not sent if Local Disarmed is YES.
Restoral
and reports are not sent if Local Armed is YES.
and Restoral reports are not sent if
Point Opening
is not sent if
4 to arm and disarm an area:
Point Response as 1. Do not connect initiating devices to a
Local Disarmed
Local Armed
as 2. The D279 should be the ONLY point in the area. The scope
Area Opening
Point Response
Point Closing. Point Closing
Local Disarmed
Point Opening
. Local bells are silenced if they were
Local Armed
is YES.
is YES.
is YES.
Closing
and reports as programmed in
Point Response
must be
must be programmed 1.
is not sent if
is YES.
EN | 71
Area
Local Alarm
is