Disarm; L## Disarm; Table 28: Authority Level Selections - Bosch D9112B Program Entry Manual

D9112B | Program Entry Guide | 3.0

Table 28: Authority Level Selections

Blank Disable this function for the authority level specified.
E Enable this function for the authority level specified. When the passcode is entered at the command
center, the panel checks the authority level. The panel executes the function only in areas where the
passcode has the authority to use the function.
When a passcode is entered into a command center that has either Account or Panel-Wide scope, the
user can use any panel-wide feature (such as Send a Report or Display Rev) as long as the user has
authority for the feature in at least one area where the command center has scope. If the function is area
specific the authority must be set for the specific function such as, Watch Mode.

Disarm

There are two disarming functions enabled by this prompt: Disarm All Areas and Disarm An Area. Blank and E
are not valid entries for this item.
Disarm All Areas: Disarms all areas according to the
entered (see Cmd Cntr Assignment).
Disarm An Area: Disarms a single area. When this function is accessed the command center displays the armed
status of areas within its
How Command Center Scope affects area execution: An Area Command Center can execute this
function only in the area where the command center is assigned. An Account command center can
execute this function in all areas in the account where the user has authority. A Panel-Wide Command
Center can execute this function in all areas in the panel where the user has authority.
Default: P
Selection: P
P Passcode is always required for this function. When the passcode is entered at the command center,
the panel checks the authority level.
The panel disarms areas where the passcode is authorized within the
center. The command center display shows the disarmed areas.
Programming in O/C Options
Closing

L## Disarm

Training Sheet
Default: See
Selection: Blank or E
Disable this function for Authority Level (L##) specified.
Blank
Enable this function for Authority Level specified. When the passcode is entered at the command
E
center, the panel checks the authority level. The panel executes the function only in areas where the
passcode is authorized.
Programming in O/C Options
Closing
Whether
Area O/C
Bosch Security Systems | 2/04 | 74-06145-000-D
User Interface
Scope
.
Area O/C
reports can be generated for a particular area.
Area O/C
reports can be generated for a particular area.
Opening Closing
and reports are generated by this user or not depends on the
L## Restricted O/C
and
Scope
of the command center where the function is
Restricted O/C
and determines whether
Restricted O/C
and determines whether
prompts in Authority Lvl Assign.
EN | 47
Scope
of the command
Opening
and
Opening
and
L##