P## Local While Armed; P## Disable Restorals; P## Returnable - Bosch D9112B Program Entry Manual

D9112B | Program Entry Guide | 7.0

P## Local While Armed

Default: No
Selection: Yes or No
Yes This option suppresses
assigned to is armed. Local annunciation of activity from this point is provided as programmed.
Note:
Local While Armed
24 hour points are always armed. To provide 24-hour protection and limit central station Alarm reports:
Note:
Local While Armed
When using this feature with keyswitch points, carefully test to make sure the desired reports are received at
the central station under all conditions.
Maintained with
Momentary: Suppresses trouble and restorals.
D279: Suppresses openings and closings
No Report events occurring from this point while the area is armed.

P## Disable Restorals

Default: No
Selection: Yes or No
Disable
Yes
point.
Enable
No
When this option is enabled, a
Restoral
when the point returns to normal after
being in an alarm or trouble
condition.
Bosch Security Systems | 2/04 | 74-06145-000-D
Point Index
Alarm Trouble
,
suppresses all reports from 24-hour points.
Type
Program point
1.
Point Response
Choose a
2.
the armed and disarmed conditions.
Enable and/or disable
3.
appropriate for the application.
affects Keyswitch Points.
Point Response
Restoral reports for this
Restoral
reports for this point.
report is sent to the receiver
Restoral
, and reports from this point while the area it is
as 1 (perimeter).
from 9 to D that provides the appropriate response in both
Local While Disarmed
1: Suppresses alarms and restorals.

P## Returnable

Use this item to automatically put this point back
into the system.
Default:
Selection:
Yes
No
Local While Armed
and
No
Yes or No
If this point was force armed, it
automatically returns to the system
when it restores to normal.
If this point was bypassed, it
automatically returns to the system
when the area is disarmed.
If this point is force armed, it stays out
of the system until the area is
disarmed.
If this point is bypassed, it stays out of
the system through arming and
disarming cycles. It can only be
unbypassed by using Unbypass a
Point (Command 00), sending the
RAM II unbypass command, or
executing an Unbypass a Point SKED.
EN | 76
as