S## Time; S## Date; S## Sunday - Bosch D9112B Program Entry Manual

D9112B | Program Entry Guide | 10.0 Skeds
Default Description
14 Adjust Time Backward One Hour. This Sked function is used to make adjustments to the panel's
clock. A typical application is to program this to take effect at 2:00 a.m. on the date that Daylight
Savings Time ends (during the fall). This function can operate only once in a day, even if multiple
Skeds with this function are programmed. No
time appears in the next report logged.
15 Sound Watch Tone at Command
Center. This function sounds the
Watch Tone at the command center
address programmed. The Watch
Tone sounds at all command
centers set for the address
programmed. Press [ESC] to silence
the tone.
Sound Watch Tone. Defines the
command center address where the
Watch Tone sounds.

S## Time

Default: _ _:_ _
Selection: HH:MM (hours and minutes)
Enter the time the Sked executes.
0101
Disabled Skeds have a Blank time. If you
0101
copy the panel and the entry for this prompt
0101
is blank, but times were at one time
programmed, the Sked may have been
disabled from the command center using
the CHANGE SKEDS function.
To program a time:
1. Press the two digits representing the hour.
2. The cursor advances past the colon (:) in the
display.
3. Press the two digits representing the minutes.
4. Press [ENT].

S## Date

Default: _ _/_ _
Selection: MM/DD or Blank
This entry selects the month and day that the Sked
operates (Date of the Year, Sked Type 1).
Leave this item blank if this Sked operates on a Day
of the Week schedule.
To program a date:
1. Press the two digits representing the month.
2. The cursor advances past the (/) in the display.
Bosch Security Systems | 2/04 | 74-06145-000-D
Sub-prompt
Time Change
report is sent or logged, but the new
S## Cmd Center
3. Press the two digits representing the day of the
month.
4. Press [ENT].

S## Sunday

This prompt and the next six-day of the week
prompts, select the days of the week that the Sked is
active. (Day of Week, Sked Type 2).
Exceptions: To prevent the Sked from activating on
certain days of the year, program
YES, and enable at least one Holiday Index. When
Xept Holiday
executes on the days of the week programmed
unless the date is designated as a holiday by the
Holiday Index selected.
If a Sked is only needed on certain days of the year,
do not program the Sked to execute on any days of
the week. Instead, program
select a Holiday Index with the dates you want the
window to be active.
Default:
Selection:
Yes
No
Selection
Enter a command center
address, 1 to 8.
Xept Holiday
is programmed YES, the window
Xept Holiday
No
Yes or No
Activate this Sked on Sundays.
Do not activate this Sked on Sundays.
EN | 92
NO, and