Set Start Scan Mode; Calibrate Touch Screen - Xerox Wide Format 6622 User Manual

System Administration

Set Start Scan Mode

You can select whether a document will begin scanning automatically once it is detected
by the Scanner, or whether it is necessary to press the Start button on the Control Panel
to initiate the scan after the document prefeeds.
The factory default setting is Automatic.
When you insert the document and manual start is enabled, you will not receive a
message to press the Start button.
1. Press the Services button on the Control Panel.
The Service menu displays.
2. Select Machine Info.
The Machine Info screen displays.
3. Select the Administration tab.
4. Select Control Panel.
The Control Panel screen displays.
5. Select Set scan start mode....
The Set Scan Start Mode screen displays.
6. Select the Automatic or Use Start key radio button.
• Automatic: Scanning starts automatically after an original is inserted into the
Scanner and prefeeds.
• Use Start key: You must press the Start button to initiate scanning after the
document prefeeds.
7. Select Save.
8. Select Close on the Control Panel screen to return to the Machine Info screen.
9. Select the Services button on the Control Panel and Copy if you intend to scan a
document at this time.
NOTE
Once this feature is enabled, users selecting options from the Services menu will
get a "press start" message.

Calibrate Touch Screen

Your User Interface Touch Screen is calibrated when it is installed. Calibration aligns the
cursor to the place on the screen that you touch. The user interface does not typically
need to be recalibrated, unless it is not working correctly or you reinstall the controller.
1. Press the Services button on the Control Panel.
The Services menu screen displays.
2. Select Machine Info from the Services menu screen.
The Machine Info screen displays.
3. Select the Administration tab.
5-18 ®
Xerox Wide Format 6622 Solution
User Guide