T5-Printout Character Set; T6-Cancel Online Ascii Hex Dump; W-Print Bar Code; X0-Set Printer In Hold Mode - Xerox 4215 Reference Manual

T5—Printout Character Set
T6—Cancel Online ASCII Hex Dump
W—Print Bar Code
X0—Set Printer in Hold Mode
@T5
Prints the character sets.
@T6
Stops Online ASCII Hexadecimal Dump.
Applying test 6 will cancel test 3 (T3).
@Wn,data@
Converts data to bar code.
n
data
Example @W1,string 1234@ prints "string 1234" as a bar code, if the bar
code definition 1 has been defined previously with function Y59.
@X0 [display_data]@
Sets the coax interface in Hold mode by command sent using
the line.
Remember
FUNCTION SELECTION VIA LINE (FSL) COMMANDS
Number from 1 to 8 indicating the bar code
number
Data must not exceed one line. Each character
must be valid for actual type, and the number of
characters must be required for the specific
code.
The upper left corner of the bar code will be in
the position of the leading escape character.
When the bar code has been printed, the printer
cursor will be located after the trialing escape
character, and printing will continue from this
point.