Table of Contents
Advertisement
User Modes
User Mode A - UA (Custom Setting Film)
This mode switches between the standard setting for film and the custom setting for
film. This feature enables the Service Representative to custom set the printer for a
brand of film that has different handling characteristics.
NOTE
The custom setting parameters (Fuser Temperature, Fuser Motor Speed, Lead
Edge Registration etc.) must first be set by the Service Representative in order
to be effective.
1. With the printer in the Standby (idle) condition, press the Menu Key 10 times to enter
Mode A.
The Menu Key lights and the display indicates UA
2. Press Enter
3. Press the --> key to change the value to 1 (On)
• Standard Setting - 0
• Custom Setting - 1
4. Press Enter key to store the value.
5. Press the Online Key to exit the User Mode.
User Mode b - Ub (Image Enhancement)
There are 4 Image Enhancement Modes that can be set to improve reproduction of gray
scale. Increasing the setting of this feature increases the density of single pixels. There
can be, however, a noticeable overall degradation in gray scale images as the setting is
increased. Experimentation will be required to achieve the correct balance.
7-10
®
Xerox
Wide Format 6622 Solution
User Guide
Advertisement
Table of Contents
