Problems With Windows Setup - NEC Express 5800 User Manual

6-26 Troubleshooting

Problems with Windows Setup

The following message is displayed when the setup starts.
The specified disk is not found. Terminating SW installation.
→ The disk to install the system is not connec
installed and connected.
The following message is displayed while copying files from CD-ROM.
xxxxx : Not Ready xxxxxxxxxxxxxxxxxxZ
xxxxx(A), xxxxx(R), xxxxx(F)
→ Press R. If this message stil
your sales agent to examine the CD-ROM drive.
Failed to se tup in detail for network adapter.
→
The detail
series. Open the control pa
configure the network adapter.
Failed to install Windows Server 2003, Enterprise Edition correctly.
Have you checked instruct
→ See "Step 1: Things
(p.4-6).
Rebooted during the setup.
→ See "Step 3:
machine's boo
ft U pdate CD is not incl
→ ft Update CD is used to u
equipment. (Not included
version of software programs at the time of shipment). For the latest release of ft control
software and purchase of the latest version of its Update CD-ROM, contact your sales
agent.
C PU Module Status LED1 and PCI Module Status LED1 are illuminating red during the
setu p.
→ This is not a failure of the module.
After the completion of a setup, CPU Module Status LED1 and PCI Module Status LED1
will be turned off at the point that each module is successfully duplicated, and, CPU
Module Status LED2 and PCI Module Status LED2 will illuminate green. See "LEDs" in
the separate volume of the User's Guide for details about the status of each module
LED's display.
l appears, perform the setup again. If the error persists, contact
ed setup of network adapter is not available in setup of NEC Express5800/ft
nel after starting Windows Server 2003, Enterprise Edition to
ions and information on installation?
Req uired for Setup" (p.4-4) and "Step 2: Prepa
Disable Boo t Monitoring Function" (p.4-11), and s
t monitorin g function to correct value.
uded.
pdate ft control software; it may not be sh
if "NEC EX
ted properly. Check if the hardware is properly
PRESSBUILDER" CD-ROM contains the latest
re for ft series Setup"
et the parameter of this
ipped with the