NEC Express 5800 User Manual page 143

This is a message for confirmation of deletion, so click [OK].
5) Close the [Add or Remove Programs] dialog box.
6) Reboot the system.
IMPORTANT:
next procedure (installation of PROSet II) without rebooting, PROSet II does not
start after reboot. The system may become unstable.
Follow the steps below to install PROSet II again if you performed system update
without rebooting the system.
1. Start a command prompt.
2. Run c:\pnpdrvrs\procomp /proset /s from a command prompt.
3. Reboot the system.
4. Set dual LAN configuration.
4. After rebooting the system, log on to the system as a user with Administrative account.
IMPORTANT:
(Check that STATUS LED 2 of each PCI module stays green.)
5. Follow the steps below to update the system:
IMPORTANT:
Uninstalled Intel(R) PROSet II at section 3 will be reinstalled at system's update.
Do not input or output data during the update process.
<If you do not have NEC Express5800/ft series ft Update CD (and use NEC
EXPRESSBUILDER CD-ROM)>
a) After logging on to the system as a user with the Administrative account, insert NEC
EXPRESSBUILDER CD-ROM into the drive.
b) When the "Master Control Menu" screen appears, click [Setup] and click [Update NEC
Express5800 system] on the menu.
<If you have NEC Express5800/ft series ft Update CD>
a) After logging on to the system as a user with the Administrative account, insert the
UPDATE CD-ROM into the drive.
Be sure to reboot before updating the system. If you perform the
Check the dual system is configured properly.
Troubleshooting 6-17