Problems With Windows Setup - NEC Express5800/340Hb-R N8800-047F User Manual

6-22 Troubleshooting

Problems with Windows Setup

The following message is displayed when the setup starts.
The specified disk is not found. Terminating SW installation.
→ The disk to install the system is not connec
installed and connected.
The following message is displayed while copying files from CD-ROM.
xxxxx : Not Ready xxxxxxxxxxxxxxxxxxZ
xxxxx(A), xxxxx(R), xxxxx(F)
→ Press R. If this message stil
contact your sales agent to examine the CD-ROM drive.
Failed to se tup in detail for network adapter.
→
The detail
series. Open the control pan
configure the network adapter.
Failed to install Windows Server 2003, Enterprise Edition correctly.
Have you checked instructions an
→
See "Step 1
(p.4-6).
Rebooted during the setup.
→ See "Step 3:
machine's boot monitorin
ft U pdate CD is not incl
→ ft Update CD is used to u
equipment. (Not included if "NEC EXPRESSBUILDER" CD-ROM contains the latest
version of software programs at the time of shipment). For the latest release of ft contro
software and purchase of the latest version of its Update CD-ROM, contact your sales
agent.
C PU Module Status LED1 and PCI Module Status LED1 are illuminating red during the
setup.
→ This is not a failure of the module.
After the completion of a setup, CPU Module Status LED1 and PCI Module Status LED1
will be turned off at the point that each module is successfully duplicated, and, CPU
Module Status LED2 and PCI Module Status LED2 will illuminate green. See "LEDs" in
the separate volume of the User's Guide for details about the status of each module
LED's display.
l appears, perform the setup again. If the error persists,
ed setup of network adapter is not available in setup of NEC Express5800/ft
el after starting Windows Server 2003, Enterprise Edition to
d information on installation?
: Things R equi red for Se
Disable Boo t Monitoring Function" (p.4-11), and s
g function to correct value.
uded.
pdate ft cont
ted properly. Check if the hardware is properly
tup" (p.4-4) and "Step 2:
rol software; it may not be shipped with the
Prepa re for ft series Setup"
et the parameter of this
l