NEC Express 5800 User Manual page 137

When you start up Recovery Console installed on the system, the screen
becomes black for a while before the screen described in the step 7 appears.
The system, however, is running. Wait that while.
6. When you start up Recovery Console from Windows Server 2003 CD-ROM, the following
message appears. Press the R key to boot Recovery Console.
Welcome to Setup.
This portion of the Setup program prepares Microsoft(R)
Windows(R) to run on your computer.
- To set up Windows now, press ENTER.
- To repair a Windows installation using
Recovery Console, press R.
- To quit Setup without installing Windows, press F3.
IMPORTANT:
The message shown above does not appear when you have started up the Recovery
Console installed on the system.
7. Follow the messages on the screen to start up the Recovery Console.
IMPORTANT:
When you restored a damaged file using the Recovery Console, update the system
described in the next section.
If you run the system without restoring files, enable the configuration for boot
monitoring function. Select [Advanced] - [Monitoring Configuration] - [Boot
Monitoring] and choose "Enabled". See "Step 11: Enable Boot Monitoring
Function" (page 4-47) for details.
To write data to a dynamic disk, settings described in "Cautions for using the
Windows Recovery Console" in "System Repair" need to be configured in advance.
For details, see "Cautions for using the Windows Recovery Console" in "System
Repair".
Troubleshooting 6-11