Problems With Windows Setup - NEC EXPRESS5800 N8800-096F User Manual

Problems with Windows Setup

The following message is displayed when the setup starts.
The specified disk is not found.
The disk to install the system is not connected properly. Check if the hardware is properly
installed and connected.
The following message is displayed while copying files from CD-ROM.
xxxxx : Not Ready xxxxxxxxxxxxxxxxxxZ
xxxxx(A), xxxxx(R), xxxxx(F)
Press R. If this message still appears, perform the setup again. If the error persists,
contact your sales agent to examine the CD-ROM drive.
Failed to setup in detail for network adapter.
The detailed setup of network adapter is not available in setup of NEC Express5800/ft
series. Open the control panel after starting Windows Server 2003 to configure the
network adapter.
Failed to install Windows Server 2003 correctly.
Have you checked instructions and information on installation?
See "Step 1: Things Required for Setup" (page 4-4) and "Step 2: Prepare for Express
Setup" (page 4-6).
Rebooted during the setup.
See "Step 3: Disable Boot Monitoring Function" (page 4-9), and set the parameter of this
machine's boot monitoring function to correct value.
GeminiEngine Control Software UPDATE CD-ROM is not included.
GeminiEngine Control Software UPDATE CD-ROM is used to update GeminiEngine
Control Software; it may not be shipped with the equipment. (Not included if "NEC
EXPRESSBUILDER" CD-ROM contains the latest version of software programs at the
time of shipment). For the latest release of GeminiEngine Control Software and purchase
of the latest version of its GeminiEngine Control Software UPDATE CD-ROM, contact
your sales agent.
During a setup, "Previous Operating System C:" was selected on a selection screen of the
operating system.
The process will be stopped along the display of DOS prompt or black screen. In this
case, press Ctrl + Alt + Delete, or turn off the power to reboot the system. Installation
will be continued after a reboot.
Terminating SW
Troubleshooting 6-15