Problems With Windows Setup - NEC N8800-103F User Manual

6-14 Troubleshooting

Problems with Windows Setup

The following message is displayed when the setup starts.
The specified disk is not found.
→
The disk to install the system is not connected properly. Check if the hardware is properly
installed and connected.
The following message is displayed while copying files from CD-ROM.
xxxxx : Not Ready xxxxxxxxxxxxxxxxxxZ
xxxxx(A), xxxxx(R), xxxxx(F)
→
Press R. If this message still appears, perform the setup again. If the error persists,
contact your sales agent to examine the DVD-ROM drive.
Failed to setup in detail for network adapter.
→
The detailed setup of network adapter is not available in setup of NEC Express5800/ft
series. Open the control panel after starting Windows Server 2003 to configure the
network adapter.
Failed to install Windows Server 2003 correctly.
Have you checked instructions and information on installation?
→
See "Step 1: Things Required for Setup" (page 4-4) and "Step 2: Prepare for Express
Setup" (page 4-7).
Rebooted during the setup.
→
See "Step 3: Disable OS Boot Monitoring Function" (page 4-9), and set the parameter of
this machine's OS Boot Monitoring function to correct value.
ft Server Control Software UPDATE CD-ROM is not included.
→
ft Server Control Software UPDATE CD-ROM is used to update ft Server Co
Software; it may not be shipped with the equipment. (Not included if "NEC
EXPRESSBUILDER" CD-ROM contains the latest version of software programs at the
time of shipment). For the latest release of ft Server Control Software and purchase of t
latest versi
agent.
During a setup, "Prev
operating sys tem.
→
The process will be stopped along the display of DOS prompt or black screen. In this
case, press Ctrl + Alt + Delete, or tu
will be continued after a reboot.
Terminating SW
on of its ft Server Control Software UPDATE CD-ROM, contact your sales
ious Operating System C:" was selected on a selection screen of the
rn off the power to reboot the system. Installation
ntrol
he