NEC Express 5800 User Manual page 90

4-48 Windows Setup
< Setup of receiving SNMP packets from specific communities only >
Change the name of the community receiving SNMP packets from the default "public"
to any name.
IMPORTANT:
If the community name is changed, the community of NEC ESMPRO Agent is changed
and registered by starting from [Control Panel]. To change the community to another
and register it, use the [SNMP Community] list box in
To allow NEC ESMPRO Agent to receive
Manager, set the send community name i
that accepted by the SNMP Service in NEC ESMPRO Agent.
7. Terminate the network setup.
IMPORTANT:
The SNMP
Service is delet
Service and then reinstall NEC ESMPRO Agent.
Some software products provided by other vendors use the SNMP Service. If the
SNMP Service and NEC ESMPRO
s oft ware as above is installed, it may be impossible to start NEC ESMPRO Agent
services. If so, delete the SNMP Service once and i
reinstall NEC ESMPRO Agent and the other vendor's software.
Setup of Firewall
When the setting of the firewall is effective, port (161/UDP) that SNMP uses is blocked.
In this case, because NEC
Manager, the server cannot be monitored from NEC ESMPRO Manager. Open the port
following the procedures below.
● Windows Server 2003 (Service Pack installed)
1. Click [Start], point to [Settings],
[Windows Firewall].
2. In the [Windows Firewall] dialog box, click [Add Port] on t
tab. In the [Add a Port] dialog box, set the values as follows, and then click
[OK].
Service is required for operating NEC ESMPRO Agent. If the SNMP
ed after the installation of NEC ESMPRO Agent, install the SNMP
Agent are installed in the system in which such
ESMPRO Agent cannot communicate with NEC ESMPRO
the [General] tab.
SNMP packets sent from NEC ESMPRO
n NEC ESMPRO Manager to be the same as
nstall the service again. After which,
click [Control Panel], and then double-click
he [Exceptions]