NEC Express 5800 User Manual page 148

6-22 Troubleshooting
a-5. The message of update completion will be displayed.
"[Update of the driver Completion]
Press any key and terminate."
b) When N8803-031F (Fibre Channel Controller) is connected
b-1 . Start up [Device Manager] by selecting [Start] - [All Programs] - [A
- [Computer Management].
Check to see [Qlogic QLA23xx PCI Fibre Channel Adapter] appears under [SCSI and
RAID Controllers].
You do not need to perform the steps b-2 and later if the number of [Qlogic QLA23xx
PCI Fibre Channel Adapter]s shown is identical to number of actually implemented
[Qlogic QLA23xx PCI Fibre Channel Adapter]s. If not, go to b-2.
b- 2. Right-click the [Unknown Device] – [Fibre Channel Controller] on the [Device
Manager], and select [Update Driver].
b -3. Select [Install from a list of specific location (Advanced)], and then click [Next].
b -4. Select [Don't search. I will choose the driver to install.], and then click [Next].
b -5. Select [SCSI and RAID Controllers], and then click [Next].
b -6. Do not select a driver on the model list. Click [Have Disk...].
b -7. Insert NEC EXPRESSBUILDER into the CD-ROM drive and click [Browse]. Specify
the "CD-ROM drive:\WINNT\DRIVERS\QL2300" folder in the "Copy manufacture's
files from:" column, and then click [OK].
b-8. Select [Qlogic QLA23xx PCI Fibre Channel Adapter] on the model list and click
[Next].
b-9. A warning message tells that you are about to update a driver. Click [Yes] to continue.
The driver will be installed. During the processing, the mouse cursor may not be moved
for 10 to 20 seconds. Please wait.
b-10.
b-11.
shown is identical to number o
Channel Adapter]s. If not, repe
c) When N8104-84 (1000BASE-SX Adapter)
c-1 . Execute [Command Prompt].
c-2 . Run the following co
C:\> CD-ROM drive:
c-3. Run the following command from Command Prompt and move to the folder with the
batch file.
CD-ROM drive:\> cd \WINNT\DOTNET\EN
c-4. Run the following command from Command Prompt for up
CD-ROM drive:\WINNT\DOTNET\EN> N810484.BAT
c-5. The message of update completion will be displayed.
"[Update of the driver Completion]
Press any key and terminate."
d) W hen N8104-103 (1000BASE-T Adapter) is connected
d-1. Execute [C
d-2. Ru n the following command from Command Prom
C:\> CD-ROM drive:
d-3. Run t he following command from Command Prompt and move t
batch file.
Click [Finish].
Check to see that the number of [Qlogic QLA23xx PCI Fibre Channel Adapter]s
mmand from Command Prompt and
ommand Prompt].
f actually implemented [Qlogic QLA23xx PCI Fibre
at the steps 2 to 10.
is connected
pt and move to CD-ROM drive.
dministrative Tools]
move to CD-ROM drive.
dating the driver.
o the folder with the