Troubleshooting; Problems With Nec Expressbuilder - NEC Express 5800 User Manual

Troublesho oting
Th is section describes what y
Proble ms with NEC EXPRESSBUILDER
When t he server is not booted from the NEC EXPRESSBUILDER C
Did you set the NEC EXPRESSBUILDER CD-ROM during POST
→ If you do not set the NEC EXPRESSBUILDER CD-ROM during POST and restart the
server, an error message will appear or the OS will boot.
Is BIOS configuration correct?
→ The boot devi
BIOS setup u
drive first.
<Menu to check: [Boot]>
When an error occurs while the NEC EXPRESSBUILDER is in progress, t
After thi s message appears, check the error and take the appropriate corrective action according t
error cod es listed in the table below.
Message
Th s machine is not supported. i
NvRAM access error
Hard disk access error
An error message will also be displayed when an error was detected during system diagnosis. Take a note
or print the error message displayed, and contact your sales agent.
ou should do when a trouble occurs in the product.
ce order may be specified with the BIOS setup utility of the server. Use the
tility to change the boot device order to boot the system from the CD-ROM
This NEC EXPRESSBUILDER version is
not designed for this server. Execute the
NEC EXPRESSBUILDER on the compliant
server.
An access to the nonvolatile memory
(NvRAM) is not acceptable.
The hard disk is not connected or it is
failed.
Check whether the hard disk is correctly
connected.
D-ROM, check the following:
Cause and Remedy

Troubleshooting

and restart the server?
he following message appears.
6-25
o the