Step 11: Set Network For Nec Esmpro Agent - NEC Express 5800 User Manual

Step 11: Set Network for NEC ESMPRO Agent

NEC ESMPRO Agent is required for continuous opera
series setup".
T o operate NEC ESMPRO Agent, you need to make setting the SNMP.
To change the settings of the
1. Double-click [Administrative Tools] in [Control Panel].
2. Start [Services] in [Administrative Tools].
3. Select [SNMP Service] from the service list and then [Properties] in the [Action] men
T he "SNMP Properties" dialog box appears.
4. Enter "public" in the [Community name] box in the [Traps] property sh
[Add to list] button.
IMPORTANT:
To change the community name of traps to be received from the default "*" in the
NEC ESMPRO Manager site, enter the same name as the community name newly set in
the NEC ESMPRO Manager site.
To receive trap from NEC ESMPRO Agent at the NEC ESMPRO Manager machine,
both community names should be the same.
5. Click the [Add...] button in [Trap destinations]. After entering the IP address of the NEC
ESMPRO Manager machine of the send destination in the [Host name, IP or IPX address]
box, click the [Add] button.
IMPORTANT:
specified as the trap send destination in the setup of the manager report (TCP/IP), the
message warning the duplication appears. The specification of the same NEC ESMPRO
Manager causes to be reported doubly.
6. Open the [Security] property sheet and make settings as follows:
•
Add the community name entered in 4 to [Accepted community names].
•
Set its authority to [READ CREATE] or [READ WRITE].
•
Select [Accept SNMP packets from any host.]
IMPORTANT:
If you entered any community name other than "public" in 4, add that name to
"Accepted community names".
Unless you set the acceptable community's authority to "READ CREATE" or
"READ WRITE," you cannot perform monitoring from NEC ESMPRO Manager.
< Setup of receiving SNMP packets from specific hosts only >
Select [Accept SNMP packets from these hosts], specify IP addresses of the hosts, IP
addresses of the servers to install Agent, and the loop-back address (127.0.0.1).
SNMP Service:
If the IP address (or host name) of the remote NEC ESMPRO Manager
Windows Setup
tion, and it is automatically installed by "ft
4-47
u.
eet and click the