NEC Express 5800 User Manual page 153

During a setup, "Previous Operating Sy
the operating system.
→ The process will be stopped along the display of DOS pr
press Ctrl + Alt + Delete, or turn off the power to rebo
continued after a reboot.
Window s can be operated after a setup but each module or PCI board is not duplicated.
(CPU Modul e Status LED2 or PCI Module Status LED2 does not light on green).
Did you abort the installation during a setup such as by closing a window
are running?
→ Installation will be aborted if you finish the programs that are running such as by closing a
window. Although the operation on Windows will be feasible, PCI boards will not be
duplicated properly if you abort the installation. In this case, "S p 1: Things Required for
Setup" needs to be done from the beginning.
Did you properly setup the duplex of HDDs?
→ PCI Module Status LED2 will not be l
(See "LEDs" in the separate volume of the User's Guide for details about the status of ea
module LED's indications.) See "Step 6: Set Dual Disk Configuration" and set up the
duplex of HDDs.
"Complete memory dump" cannot be specified to the write debug in
Memory Dump" (Debug Information).
→ "Complete memory dump" cannot be specified (not displayed) if the m
2GB. Specify "Kernel memory dump" in this case.
Cannot find the reco
→ See "Size of the Partitio
Cannot sp ecify a network path for the storage location of diagnosis information (collec
log) in "Set Dr . Watson".
→ You cannot specify a network path. Specify a path to a local computer.
The erro r message "An Error occurred while creating partition." appears when installin
the OS.
→
If the following message appears when installing the OS using NEC EXPESSBUILDE
you need t
Referring to Chapter 4 "SYSTEM BIOS" in the separate volume of the User's Guide,
change the status of [Option ROM Scan Monitoring] to "Disabled" and perform the
Low-Level Format again.
Then, after performing the Low-Level F
Monitoring] to "Enabled".
"An Error occurred while creating partition. Press CTRL-C to terminate installation."
mmended value for a paging file.
n to be Created" in "Step 1: Things Required for Setup".
o perform the Low-Level Format again due to reasons including interruption.
stem C:" was selected on a selection screen of
it in green if a setup for duplex is not performed.
ormat, change the status of [Option ROM Scan
Troubleshooting
ompt or black screen. In this case,
ot the system. Installation will be
of the programs that
te
formation on "Set
emory size exceeds
6-27
ch
t
g
R,