Appendix 1 Messages And Leds - Toshiba B-EX4T1 Series Owner's Manual

APPENDIX 1 MESSAGES AND LEDS

APPENDIX 1 MESSAGES AND LEDS
Appendix 1 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: %%,%%%,%%%: Remaining memory size of the external memory: 0 to 09,999,999 (in K bytes)
4: ####: Remaining memory size for PC commands storage area in the internal memory: 0 to 3072 (in K bytes)
5: &&&&: Remaining memory size for writable characters storage area: 0 to 3147 (in K bytes)
LCD Message
No.
ON LINE
1
ON LINE
2 HEAD OPEN
3 PAUSE
4 COMMS ERROR
5 PAPER JAM
6 CUTTER ERROR
7 NO PAPER
8 NO RIBBON
9 HEAD OPEN
10 HEAD ERROR
11 EXCESS HEAD TEMP
12 RIBBON ERROR
13 REWIND FULL
SAVING####KB/&&&&KB
14 or
SAVING%,%%%.%%%KB
FORMAT####KB/&&&&KB
15 or
FORMAT%,%%%.%%%KB
16 NOW LOADING...
17 MEMORY WRITE ERR.
18 FORMAT ERROR
19 MEMORY FULL
Display of error message
20
(See Notes.)
: The LED is flashing.
LED Indication
ONLINE ERROR
In online mode
In online mode (The printer in
communication)
The print head block is opened in
online mode.
The printer is paused.
A parity, overrun, or framing error has
occurred during communication
through the RS-232C.
The media is jammed during paper
feed.
A problem has occurred with the cutter
module.
The media has run out, or the media is
not loaded properly.
The ribbon has run out.
Feed or printing was attempted with
the print head block open.
There is a problem with the print head.
The print head is overheated.
The ribbon has been torn. A problem
has occurred with the sensor that
determines the torque for the ribbon
motor.
An overflow error has occurred in the
rewinder unit.
Writable character or PC command
save mode
The storage area is being initialised.
TrueType font or BASIC program is
being downloaded.
An error has occurred while writing to
flash memory or USB memory.
An erase error has occurred while
formatting the flash memory or USB
memory.
Data cannot be stored because the flash
memory or USB memory is full.
A command error has occurred while
analyzing the command.
EA1- 1
: The LED is unlit.
Printer Status
ENGLISH VERSION EO1-33089
APPENDIX 1 MESSAGES AND LEDS
Acceptance of
Restoration by
Status Request/
RESTART key
Reset Command
Yes/No Yes/No
----- Yes
----- Yes
----- Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
No Yes
Yes Yes
Yes Yes
----- Yes
----- Yes
----- Yes
No Yes
No Yes
No Yes
Yes Yes